This article may benefit from a new introduction. You can help wikiHow by improving the current introduction, or writing a new one to match the format described in the Writer's Guide. Please remove this notice once this page has been improved. Notice added on: 2010-10-29. |
Steps
-
1Cut a large shaft of bamboo, then decide how long you want your pipe to be. Stay between 8 inches (20.3 cm) and 3 feet (0.9 m) because it will be difficult to hollow out the shaft. Make sure that you have cut the length of the pipe, diameter of the shaft is about half an inch.Ad
-
2Find your drill, find your longest bit. You might want to go and buy a long bit or a few bit extenders. Begin to hollow the shaft of bamboo out from one side, or both depending on were you want your carb.
-
3Run the shaft under some running water to clean out the debris. You might floss the shaft with a rag.
-
4Find a socket wrench set and find the socket that fits your preferred amount of substance, then drill a hold to fit the socket to one side of the shaft then drill a small hole behind the socket.
-
5Drill the hole just big enough to force the socket in to place so it will stay in place.
-
6Go to the hardware store and buy a sink faucet head then dismantle it to extract the screen then fit it accordingly to the pipe shaft if you're cheap you can shove a cotton ball or tampon in to the shaft this will also act as a filter
-
7Buy the screens for about a dollar if you don't want to dismantle a sink faucet head.Ad
We could really use your help!
conflict management?

mango salsa?

horses?

nebulizers?

Tips
- If no power saw is avalanche use hacksaw
- If no drill is available use a knife just use it like a spoon drill
Warnings
- Smoking is hazardous to your health
- Be careful using power tools
Article Info
Categories: Summarization | Pipe Smoking
Thanks to all authors for creating a page that has been read 9,442 times.
About this wikiHow