ICD 4 Standard Communication

The main interface to the target processor is via standard communication. It contains the connections to the high voltage (VPP), VDD sense lines, and clock and data connections that are required for programming and connecting with the target devices.

The VPP high-voltage lines can produce a variable voltage that can swing from 0-14 V to satisfy the voltage requirements of the specific emulation processor.

The VDD sense connection draws very little current from the target processor. The actual power comes from the MPLAB® ICD 4 In-Circuit Debugger system, as the VDD sense line is used as a reference only to track the target voltage. The VDD connection is isolated with an optical switch.

The clock and data connections are interfaces with the following characteristics:

  • Clock and data signals are in high-impedance mode (even when no power is applied to the MPLAB ICD 4 In-Circuit Debugger system)
  • Clock and data signals are protected from high voltages caused by faulty target systems, or improper connections
  • Clock and data signals are protected from high current caused by electrical shorts in faulty target systems

6-pin Standard Pinout

6-PIN-STANDARD-PINOUT.PNG

Electrical Logic Table

Logic Inputs VIH = VDD x 0.7 V (min.)
VIL = VDD x 0.3 V (max.)
Logic Outputs VDD = 5 V VDD = 3 V VDD = 2.3 V VDD = 1.65 V
VOH = 3.8 V min. VOH = 2.4 V min. VOH = 1.9 V min. VOH = 1.2 V min.
VOL = 0.55 V max. VOL = 0.55 V max. VOL = 0.3 V max. VOL = 0.45 V max.

Modular Cable and Connector
For standard communication, a modular cable connects the debugger and the target application. The specifications for this cable and its connectors are listed below.

Modular Connector Specification:

  • Manufacturer, Part Number – AMP Incorporated, 555165-1
  • Distributor, Part Number – Digi-Key, A9031ND

The following table shows how the modular connector pins for an application correspond to the microcontroller pins. This configuration provides full in-circuit debugger functionality.

Modular Connector Pinout of Target Board

MODULAR-CONNECTOR-PINOUT-OF-TARGET-BOARD.PNG

Modular Plug Specification:

  • Manufacturer, Part Number – AMP Incorporated, 5-554710-3
  • Distributor, Part Number – Digi-Key, A9117ND

Modular Cable Specification

Modular Cable Part Number 07-00024

The length of this cable (L) is 6 inches. We recommend that you do not use a modular cable longer than 6 inches in order to avoid potential communication problems.

modular-cable.PNG
​

  Return to Top

© 2020 Microchip Technology, Inc.
Notice: ARM and Cortex are the registered trademarks of ARM Limited in the EU and other countries.
Information contained on this site regarding device applications and the like is provided only for your convenience and may be superseded by updates. It is your responsibility to ensure that your application meets with your specifications. MICROCHIP MAKES NO REPRESENTATIONS OR WARRANTIES OF ANY KIND WHETHER EXPRESS OR IMPLIED, WRITTEN OR ORAL, STATUTORY OR OTHERWISE, RELATED TO THE INFORMATION, INCLUDING BUT NOT LIMITED TO ITS CONDITION, QUALITY, PERFORMANCE, MERCHANTABILITY OR FITNESS FOR PURPOSE. Microchip disclaims all liability arising from this information and its use. Use of Microchip devices in life support and/or safety applications is entirely at the buyer's risk, and the buyer agrees to defend, indemnify and hold harmless Microchip from any and all damages, claims, suits, or expenses resulting from such use. No licenses are conveyed, implicitly or otherwise, under any Microchip intellectual property rights.