Edit

How to Use the Slider in SketchyPhysics

Edited byTeresa (see all) and 1 other

Article
Edit Discuss History
Use the Slider in SketchyPhysics

If you want to control the path that an object would take, then you can do it with the Slider in SketchyPhysics. This article shows you how to use it.

Edit Steps

  1. 1
    The requisite floor
    The requisite floor
    Start off with the floor that you need to make SketchyPhysics work.
  2. 2
    Click on the Slider icon.
  3. 3
    Move to where you want your slider to begin its slide.
    Move to where you want your slider to begin its slide.
    Move to where you want your slider to begin its slide. In this case, it starts from the back of the cylinder.
  4. 4
    Take it in the direction you want.
    Take it in the direction you want.
    Take it in the direction you want. In the screenshot, it is going through the cylinder and along the green axis.
  5. 5
    Click on the Joint Connector.
  6. 6
    Click on the slider you have placed.
  7. 7
    Press and hold down CTRL.
  8. 8
    Connected joints
    Connected joints
    Click on the object, cylinder in this case.


Edit Video


Edit Related wikiHows

Articles for You to Write

Here is a list of suggested articles that have not yet been written. You can help by researching and writing one of these articles. To get started writing one of these articles, click on the red link of a title below.

Article Info

Last edited:
March 18, 2012 by Clarinetdude

Categories:
SketchyPhysics

Recent edits by: Teresa (see all)

Article Tools

Share this Article:

Thanks to all authors for creating a page that has been read 505 times.

Was this article accurate?

YesNo


x

Thank Our Volunteer Authors.

Give this article a +1.